 |
Calculating Vertex Normals for Height Maps
Submitted by |
I had the problem that for surfaces defined by a heightmap like terrain or
water calculating the vertex normals the normal way, by averaging all
adjacent surface normals after the heightmap is triangulated, seemed to be
slow (especially for a big heightmap and if you do it often, like every
frame for water).
Now what I do is calculate the vertex normal only based on the height map
(similar to converting a heightmap to a normal map I guess). For every
vertex normal I take 4 samples (left, right, top bottom of the current
heightmap pixel) this gives me the average slopes in x and z direction. This
results in two "2D" vertex normals (one in x, one in z direction). Now I
only have to find a 3D vector, that projected to the x=0, z=0 planes gives
the same slopes as the "2D" normals and normalize it. Well, maybe it's best
explained by looking at the code snippet below. The method should be
considerably faster than doing all those crossproducts.
(The normals calculated this way are independent of the later triangulation
of the heightmap, so they are not the same you'd get by averaging the
surface normals, but this is not noticeable in the result.)
// unsigned char h(x, y) returns the height map value at x, y.
// the map is of size width*height
// Vector3 normal[width*height] will contain the calculated normals.
//
// The height map has x, y axes with (0, 0) being the top left corner of the map.
// The resulting mesh is assumed to be in a left hand system with x right, z into the screen
// and y up (i.e. as in DirectX).
//
// yScale denotes the scale of mapping heights to final y values in model space
// (i.e. a height difference of 1 in the height map results in a height difference
// of yScale in the vertex coordinate).
// xzScale denotes the same for the x, z axes. If you have different scale factors
// for x, z then the formula becomes
// normal[y*width+x].set(-sx*yScale, 2*xScale, xScalesy*xScale*yScale/zScale);
for (unsigned int y = 0; y<height; ++y)
{
for (unsigned int x = 0; x<width; ++x)
{
// The ? : and ifs are necessary for the border cases.
float sx = h(x<width-1 ? x+1 : x, y) - h(x0 ? x-1 : x, y);
if (x == 0 || x == width-1)
sx *= 2;
float sy = h(x, y<height-1 ? y+1 : y) - h(x, y0 ? y-1 : y);
if (y == 0 || y == height -1)
sy *= 2;
normal[y*width+x].set(-sx*yScale, 2*xzScale, sy*yScale);
normal[y*width+x].normalize();
}
} |
|
The zip file viewer built into the Developer Toolbox made use
of the zlib library, as well as the zlibdll source additions.
|
